Instead of buying an expensive frame that was large enough for a queen size mattress and provided storage I decided and be cheap and build one dubbed The Princess Bed or Big Girl Princess Bed because it’s so tall and my wife is so short.
- 6x 2×4
- 4×8 sheet of half inch plywood
- Reciprocating saw
- Circular saw
The sides of the shelving came whole instead of 2 pieces so I had to cut out the supports using a reciprocating saw then cut them in half using a metal cutoff wheel on my circular saw. The bed was a bit too tall after this so I went back and cut another 2-3″ of each leg. Because the supports were welded in place I had to cut new 2×4 angled supports to make the bed more rigid. The 2×4 supports for the mattress are just the right height so that the cuts on the shelving did not have to be exactly even. The plywood was cut to fit the platform and then covered with canvas to protect the mattress.
Next for this project is a small staircase with additional storage inside.